Reasons Why The Tattoo Machine Does Not Start?

Reasons Why The Tattoo Machine Does Not Start?

Causes and solutions to the faults

1. The elastic rod does not touch the contact of the oblique spring. Loosen the screw of the elastic rod and rotate the elastic rod downward to touch the contact. Then rotate it to the appropriate position and tighten the screw to lock the elastic rod.
_______________________________________
2. The power switch is not turned on. Turn on the power. Turn on the power switch and the indicator light is red.
3. The adjustment button (VOLTAGE) is at zero position, and the V meter pointer is also at zero position. The adjustment button rotates slowly clockwise, and the V meter pointer also rotates. The V meter pointer should stop at 6-10V.
4. The elastic rod touches the front spring contact. If it is too tight, it cannot start and may cause a power short circuit. Turn on the power switch and the indicator light will be green. There is no voltage. Loosen the screw of the elastic rod, loosen the elastic rod upward from the spring contact, and adjust the elastic rod to touch the contact again. Restart the power and change the elastic rod to the appropriate position.

5. Stopping the machine during operation: Often during operation, the power cord is pulled accidentally and unclear when leaving the joint position.
Check the foot switch and whether the power cord plug is in place
6. After the work is completed when cleaning and disinfecting the tattoo machine, the wire on the machine is pulled off (dislocated). Check whether the wire head on the tattoo machine is dislocated (broken). Find an electrician to solder the wire
7. When the power is turned on, the indicator light turns green. Check whether the plug on the power cord and the plug on the foot switch are broken. If they are broken, they may touch the wire (short break). If the wire head is broken, use a soldering iron to solder it, and it will be OK!
Does the quality of the tattoo machine determine whether the tattoo work is easy?
--- Tattoo machines around the world have different styles, but the working principles are similar. There is a world of difference in working performance, needle frequency and needle wave are different, working time is different, and the degree of fragility of consumables is also different.
--- A machine with good performance has a high number of punctures into the skin per second (high needle frequency); a high number of punctures into the skin at the same depth per second (low needle wave); secondly, a long continuous working time. Thirdly, whether the machine design is suitable for people's operating habits (whether it is scientific and reasonable).
Working principle and debugging method of tattoo machine:
The tattoo machine converts the external 220V AC power into DC power with a voltage value between 3-20V through the intermediate voltage regulator and transformer. Under the DC voltage of 3-20V, the two main coils and the electrospray point produce an instantaneous suction and spraying effect, and with the reciprocating motion of the tattoo machine spring sheet, the tattoo needle is driven to produce high-speed up and down and reciprocating motion. The biggest benefit of this working method is that since it is not driven by a motor, there is no need to consider the power loss of the motor, so it can produce high speed and high torque. When working, the tattoo needle pierces the epidermis at high speed and evenly, and the tattoo pigment is implanted into the basal layer of the epidermis, making the pigment permanently fixed in the epidermis, forming exquisite patterns and texts with various pigment combinations, to modify the skin and cover epidermal scars.

Reading next

How to Maintain a Tattoo Machine?
Steps For Debugging The Tattoo Machine?

Leave a comment

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.